Cylinder Heads and Camshaft Housings Installed

A few more steps to completion.

Heads Installed, Left Camshaft Housing Test Fit

Heads Installed, Left Camshaft Housing Test Fit

Camshaft Housings Installed, Knock Sensors Installed

After a great deal of agony over the choices, I used Threebond 1184 for sealing the camshaft housings to the cylinder heads.  Fingers crossed I did it well!

On the knock bridge and knock bridge sensor, I used a bit of purple Loctite with the appropriate primer.  Apparently the aluminum hole and plated steel fastener may not be enough to "cure" the Loctite.  Given the engine's heat and the temperatur profile of the Loctite, I am somewhat skeptical that this will do much, but I figured it wouldn't hurt much either.

P&C's Installed

Noting a little milestone along the way...pistons and cylinders installed.

Little sections of PVC pipe work great if you don't have enough spare sockets to hold the cylinders in place.  I used left-over 3/4" schedule 40 from the clean room construction, but a smaller diameter would probably be a bit better.

Engine reconstruction commences!

Family heads out, wrenching commences

With the family off to the grandparents' for the weekend (thanks everyone!), I set about beginning engine reconstruction.  However, before that could begin, I needed to finish building my "clean room".  I thought about just reserving the garage for engine building, but given my rate of progress, that didn't seem like a good idea.

The clean room complete

It has AC!

Ready to begin

A ding in the cylinder-head mating surface - the next bump in the road. But this piston looks good!

Piston when first disassembled

SAI Pump Wire Insulation

A known weakness, the insulation falls of the wires leading to the SAI pump.  I addressed it by knocking off the old insulation and replacing it with Ancor marine-grade shrink wrap (1/4").  Not only did this shrink wrap seem extra sturdy, but it shrinks to 1/3 it's original diameter.  This allows it to clear the collar on the plug and still shrink tight around the wire.  But next time, I would probably just replace the wires.